Msp3400 0-0040: MSP3410G-B11 supports nicam and radio, mode is autodetect and autoselect
Pinnacle tv center serial code pro#
Pinnacle PCTV Pro bought in Sweden (PAL).īttv0: Bt878 (rev 17) at 0000:01:09.0, irq: 17, latency: 16, mmio: 0xfdeff000īttv0: detected: Pinnacle PCTV, PCI subsystem ID is 11bd:0012īttv0: using: Pinnacle PCTV Studio/Rave īttv0: gpio: en=00000000, out=00000000 in=00fffbff It started working! Must be some bug, since only "tuner=33" didn't work either. The card was autodetected by bttv as card=39, but didn't work. Memory at e2001000 (32-bit, prefetchable) not foundĠ0:0a.0 Multimedia video controller: Brooktree Corporation Bt848 Video Capture (rev 12)įlags: bus master, medium devsel, latency 32, IRQ 21 not foundīttv0: i2c: checking for TDA9887 0x86. not foundīttv0: i2c: checking for TDA7432 0x8a. foundīttv0: miro: id=1 tuner=0 radio=matchbox stereo=yes Msp3400 2-0040: MSP3410D-B4 supports nicam, mode is autodetectīttv0: i2c: checking for MSP34xx 0x80. The cards may be detected automatically, but at least for the Pro card is is required to specify options explicitly in /etc/nd (for Fedora, other distributions may do it differently):īttv: using 8 buffers with 2080k (520 pages) each for captureīttv0: Bt848 (rev 18) at 0000:00:0a.0, irq: 21, latency: 32, mmio: 0xe2001000īttv0: using: MIRO PCTV pro īttv0: gpio: en=00000000, out=00000000 in=00e707df
Pinnacle tv center serial code serial#
Rather, the remote control sensor cable (supplied) is connected to a 9 pin serial input (usually there is one on your motherboard).
They are based on the Bt848 chip (Also see Bttv devices (bt848, bt878)). These Miro and Pinnacle cards were the original PCTV series, produced from December 1997 onwards.